https://www.mscdirect.com/browse/tn/?searchAheadTerm=corner+radius+end+mill&searchAhead=true&hdrsrh=true&typahddsp=Corner+Radius+%26+Corner+Chamfer+End+Mills&navid=12106244
On Thu, Jun 29, 2017 at 11:21 AM, sam sokolik <[email protected]> wrote: > maybe > > corner radius end mill > > sam > > On 6/29/2017 10:32 AM, andy pugh wrote: > >> For much of the sort of thing that I make, a bull-nose cutter (ball nose >> with a flat section on the end) would be ideal. They can do nearly >> anything >> that a ball-nose can, with the additional ability to make flat horizontal >> surfaces. >> >> My CAM packages all know how to work with them, but I don't actually seem >> to be able to see them on sale anywhere. (Or, at least, not in the UK) >> >> Are these always ground in-house, or perhaps they have an alternative name >> that I should try searching for? >> >> > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Addressee is the intended audience. If you are not the addressee then my consent is not given for you to read this email furthermore it is my wish you would close this without saving or reading, and cease and desist from saving or opening my private correspondence. Thank you for honoring my wish. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
