solid carbide end mills tend to be expensive :) On Thu, Jun 29, 2017 at 3:18 PM, andy pugh <[email protected]> wrote:
> On 29 June 2017 at 20:59, Stuart Stevenson <[email protected]> wrote: > > > https://www.mscdirect.com/browse/tn/?searchAheadTerm= > > corner+radius+end+mill&searchAhead=true&hdrsrh=true& > > typahddsp=Corner+Radius+%26+Corner+Chamfer+End+Mills&navid=12106244 > > > Which led me to: > > https://www.mscdirect.co.uk/CGI/INSRCH?Ntx=mode+ > matchallpartial&Ntk=Keyword+Search&Ne=115&N=2014437+ > 4294824304&Ntt=corner+radius > > As is typical for MSC, they are very expensive, though. > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is designed > for the especial use of mechanical geniuses, daredevils and lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1916 > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Addressee is the intended audience. If you are not the addressee then my consent is not given for you to read this email furthermore it is my wish you would close this without saving or reading, and cease and desist from saving or opening my private correspondence. Thank you for honoring my wish. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
