I am trying to get my 7i43 configuration to run. LinuxCNC shutdown reporting pin not found for “scale.spindle.gain".
I found the following lines in my .hal config that seem relevant. loadrt scale names=scale.spindle addf scale.spindle servo-thread setp scale.spindle.gain 60 net spindle-fb-filtered-abs-rps abs.spindle.out => scale.spindle.in net spindle-fb-filtered-abs-rpm scale.spindle.out Does anything stand out as an error? Thanks, Alan ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
