Thanks Andy, I found the error. The hal source on my Mac wasn’t the same as that on my linuxcnc box. I got the loadf’s and addf’s setup correctly now. However, now I am getting the error “Epp timeout while sending firmware".
Would the error message for timeout be the same if it failed to find the file? Where is the firmware (bit file) that is to be loaded found? I have a 7i43p 200K board. Thanks in advance, Alan > On Jun 29, 2017, at 9:30 PM, Condit Alan <[email protected]> wrote: > > I am trying to get my 7i43 configuration to run. LinuxCNC shutdown reporting > pin not found for “scale.spindle.gain". > > I found the following lines in my .hal config that seem relevant. > > loadrt scale names=scale.spindle > > addf scale.spindle servo-thread > > setp scale.spindle.gain 60 > > net spindle-fb-filtered-abs-rps abs.spindle.out => scale.spindle.in > net spindle-fb-filtered-abs-rpm scale.spindle.out > > Does anything stand out as an error? > > Thanks, > Alan ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
