On 17 August 2017 at 19:50, Eric H. Johnson <ejohn...@camalytics.com> wrote:
> I know this is a pre release, but I notice one significant difference. I blew > the fuse on the 5V PS which powers the 7i43 and started up not realizing it > had blown. Lcnc seems to lock up when it cannot talk to the 7i43. I was > pretty sure in the previous release that it would give a meaningful error > message and shut down gracefully when it could not talk to the board. That is odd, because other than my recently-reverted change I don't think anything else has been altered. -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users