Andy, Sebastian, I am unfortunately at the shop and can only get Internet through my phone. So I am running half blind as far as Lcnc doc. Which version do I need to run that supports gantry homing with opposing motors (added JOINT section to the ini file).
It is that version I need to get back to, which when I did it was only available in pre. I thought that version was now released. Thanks, Eric On August 16, 2017 1:25:49 PM EDT, andy pugh <bodge...@gmail.com> wrote: >On 16 August 2017 at 17:30, Sebastian Kuzminsky <s...@highlab.com> >wrote: > >> That's terrible! What version of linuxcnc were you running? Was >this an >> RTAI build? > >This is probably my fault. > >https://github.com/LinuxCNC/linuxcnc/commit/036bdd6eccc42ac8c878e54dce1343f58454f2f9 > >I thought that I had time to get some hardware to properly test it on, >as I pushed it to 2.7 and forgot that it would eventually merge up to >2.8. >(my thinking was that as long as I got it fixed before the next 2.7 >release it would be OK) > >Anyway, I have reverted it in 2.7 and hopefully it will merge up to >Master soon. > >Very sorry for the inconvenience. > >-- >atp >"A motorcycle is a bicycle with a pandemonium attachment and is >designed for the especial use of mechanical geniuses, daredevils and >lunatics." >— George Fitch, Atlanta Constitution Newspaper, 1916 > >------------------------------------------------------------------------------ >Check out the vibrant tech community on one of the world's most >engaging tech sites, Slashdot.org! http://sdm.link/slashdot >_______________________________________________ >Emc-users mailing list >Emc-users@lists.sourceforge.net >https://lists.sourceforge.net/lists/listinfo/emc-users -- Sent from my Android device with K-9 Mail. Please excuse my brevity. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users