Greetings everybody; It occurred to me later last night, that these following errors absolutely have to be bus or card failure related. The LCNC system has no feedback from the motors, only from the 5i25. So as long as thats working, I ought to be able to jog an axis at a reasonable speed until it thinks its run into a software set limit and do it without any following errors as long as the card is reporting back to LCNC that it has moved the motor by however far it was commanded to move.
Ok, so test. I also have another Dell of that same vintage but a slower p4 cpu. And while I use it mainly for programming the 5i25's, it does have linuxcnc installed. So it could serve as a test mule. Stay tuned. Sometimes my one track mind can't see the trees for all the forest. :( An even newer patch for rt kernels was released on the linux-rt list this morning, so I have the rock64 building that, 4.11.12-rt16. I'll test that when I figure out how the rock64 selects it versions to boot, its not clear to me yet. ATM its running the issue stretch kernel. So many irons, so little fire... Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
