Well I bit the bullet and ordered one of those tiny little guys.  So now
it's a waiting game for the Radeon 9200 video board for $11 and the little
SSD.  Both slated for end of October to Mid November.  By then I should have
the X axis Motor mounts cast and machined.

Meanwhile, just tested the Z axis output to a UHU controller with a 24V
motor that has a 360 line encoder from the PC parallel port.  No issues so
far.

I still want to play more with the Beagle but at least I do have a fallback.
Thanks for everyone's help.
John


> -----Original Message-----
> From: Jon Elson [mailto:el...@pico-systems.com]
> Sent: October-19-17 5:04 PM
> To: Enhanced Machine Controller (EMC)
> Subject: Re: [Emc-users] PC MB for Linux.
> 
> On 10/18/2017 11:14 PM, John Dammeyer wrote:
> > I do have one question about this module just before I order one.  Is
the
> Debian LinuxCNC set up to _not_ use the 'hard drive' for any temp files?
> > Over time it wouldn't take long to wear out the FLASH memory.
> I've been using an SSD drive in my main desktop since 2013,
> with no sign of degradation.  I have heard of some guys who
> were using SSDs on compile farms that did manage to wear
> them out in a year or so. There are some file system
> settings like noatime that reduce writing to the directory.
> 
> Jon
> 
>
----------------------------------------------------------------------------
--
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users


------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to