On Friday 27 October 2017 11:19:09 Przemek Klosowski wrote:

> On Tue, Oct 10, 2017 at 4:07 AM, Erik Christiansen
> <dva...@internode.on.net>
>
> wrote:
> > On 09.10.17 09:06, sam sokolik wrote:
> > > I am very doubtful that the red dye is causing the problem..  (I
> >
> > dissected a
> >
> > > few styes - all have shielded pairs)
> >
> > Agreed. To see if the described "powdered copper wire" was the
> > cause, I hacked into my replaced cable last night, and found that
> > there's Al foil and a lot of clear polyethylene (or similar) in
> > between. Furthermore, the substantial tinned conductors were
> > pristine.
> >
> > So all I can truly report is that nothing would bring the machine
> > back to life until I replaced the cable, and boot times and disk
> > performance are 2 - 4 times better than shortly before it went
> > catatonic. Reason? Dunno. So just a time-saving fortuitous
> > coincidence?
> >
> > Could it be oxidation on the connector? vigorous unplugging and
> > replugging wiping it clean, perhaps?

If I'm correct, that will do little for the problem, and likely the 
handling will make it much worse. BTDT, quite a few times. As a side 
note, Dell makes pretty good machines, I have 3 now. All still running 
on the OEM cables and they aren't red. So they must also know about 
this. To test, take a plastic tool, and just move the middle of the 
cable an eighth inch.  If the log explodes with drive resets, there is 
your answer.

Cheers, Gene Heskett
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
Genes Web page <http://geneslinuxbox.net:6309/gene>

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to