Of course. Silly me. EMC2-Inch.spm. I did run the general.spm output with the G90.1 entered from the MDI line first. Then the file actually ran without issues. Now I'm running the EMC2-Inch.spm post processor file and it loaded and is running without incident. This file has a G90 and a the G91.1 is still set. I guess G90 over-rules G91.1?
In either case. That's working. Thanks John > -----Original Message----- > From: andy pugh [mailto:[email protected]] > Sent: October-29-17 1:21 PM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] G-Code > > On 29 October 2017 at 17:56, John Dammeyer <[email protected]> > wrote: > > > But no LinuxCNC.spm. > > Is there an "emc.spm"? LinuxCNC used to be called EMC2 and some > post-processors haven't caught on to the name-change. > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > � George Fitch, Atlanta Constitution Newspaper, 1916 > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
