I have a small two axis rotary here that I will donate to Gene. You can make a 5 axis mill! It may be too big for you but I will dig it out and snap some pics next to a tape measure.
If Gene does not want it I will let it go to the first offer of $100.00 to anyone on the list. Let me know if anyone has any interest. I sold the mill I was going to use it on so it just sits on a pallet collecting dust. Jeff Johnson [email protected] Superior Roll & Turning 734-279-1831 I am half-heartedly looking for a rotary table, smallish but without any huge backlash, for use on the g0704. A 4" chuck would hold most of what I might do. I have one now, but backlash is relatively huge and variable because the bull gear is eccentric, and it hasn't a working well enough as a clamp facility to hold against cutting forces. Best I've been able to do is draw the bolt down, and injecting air at 100 psi or so into the seat to unlock it enough that a 225 oz motor can turn it. That of course drives the grease out of the central bearing too. Gotta be a better way. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ********* ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
