I'm slowing getting set up to test one of those sensors. I just 3d printed a holder. The darn thing uses M12x1 threads so I had to order a 12x1 tap 6 weeks from China and the tap arrived. Printing 12x1 almost works but you need to chase out the printed threads. None of the local stores carry anything that is M12x1. Soon enough I will know if it can "see" things like hex bolt heads and aluminum foil.
On Tue, Feb 13, 2018 at 5:04 PM, jeremy youngs <jcyoung...@gmail.com> wrote: > I had to service this motor today, as a previous technician had improperly > installed the brushes and it would are off at speed. In doing so I removed > the tach cover and found plenty of room for an omron encoder. So I will not > likely try these for spindle encoder. But will be putting them in as home > switches soon. > > Gene, you are absolutely right about the optos, the strongest and best > these have performed today after I replaced the bob to a straight through > board. However, I discovered my y axis ballscrews is bent. It's been in > there 4 years now and was kinda jury rigged anyhow. So I guess it's time to > jump that hurdle, may as well put one in x as well. > Now where's that box with pulleys and belt in it from China that has been > setting in Chicago for 2.5 weeks....... > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Chris Albertson Redondo Beach, California ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
