Probably about 25mm shaft. So as I need 1000 to 1500 RPM for the
plastics it seems doable then.
------ Original Message ------
From: "Ed" <ate...@mwt.net>
To: emc-users@lists.sourceforge.net
Sent: 2018-04-02 16:58:56
Subject: Re: [Emc-users] What RPM
On 04/02/2018 09:23 AM, Marius Liebenberg wrote:
Hi
I have had this piece of machine in the store for a long time. I think
it was used to decant fishing line to the smaller plastic reels.
I have a need for a small dedicated lathe that will onpy cut soft
materials like plastic and aluminium occasionally.
The spindle in the picture is what is currently fitted to the machine
and I would like to refurbish and use it. The question I have is what
RPM will I be able to run the spindle seeing that it uses these brass
bearings?
Depending on diameter, I would treat it like an old lathe with bronze
bearings. 1000 RPM should be no problem with adequate oil lube.
Ed.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users