On 8 April 2018 at 22:40, Gene Heskett <[email protected]> wrote: > Putting the final touches on a routine to tap a 4mm.70 hole, and geany > says it is saving the changes, by removing the red text for normal text > in its header bar, but I'm leaving the file open in geany, and going > back to lcnc, which also goes thru the motions of reloading the file. > > But neither less from a shell from here ssh logged into that machine, nor > LCNC on that machine loads the new code.
Are you sure that you are saving to the right place? I only ask because I managed to save an old config over my working config today when Geany lost the network drive and went back to a local drive containing a file of the same name. -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
