On Sunday 08 April 2018 17:44:16 andy pugh wrote: > On 8 April 2018 at 22:40, Gene Heskett <ghesk...@shentel.net> wrote: > > Putting the final touches on a routine to tap a 4mm.70 hole, and > > geany says it is saving the changes, by removing the red text for > > normal text in its header bar, but I'm leaving the file open in > > geany, and going back to lcnc, which also goes thru the motions of > > reloading the file. > > > > But neither less from a shell from here ssh logged into that > > machine, nor LCNC on that machine loads the new code. > > Are you sure that you are saving to the right place? > I opened the file via that name, and the saves (ctrl+s) had been working all day. This machine has a 60 GB SSD for a drive. And from here, there is only one "tap4mmhole.ngc" in the nc_files directory. I did an updatedb, then a "locate tap4mmhole.ngc", and theres a copy in the linuxcnc dir too. But its nowhere near the same file, and has a creation date 2 years back. Next I guess is to close geany w/o any saves, and rerun it. Except I, nor root can kill it. Go back out there and try. And out there, geany is gone from the workspace it was on, but still shows in a root session of htop, which cannot kill it. Shut down lcnc so it was a gracefull shut down, and reboot it I guess. I'll go back out and see if I can edit that file in a bit, helping Dee at the moment.
Weird stuff for sure. Thanks Andy. > I only ask because I managed to save an old config over my working > config today when Geany lost the network drive and went back to a > local drive containing a file of the same name. -- Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
