> -----Original Message----- > From: Gene Heskett [mailto:[email protected]] > Sent: Sunday, August 05, 2018 12:57 PM > To: [email protected] > Subject: Re: [Emc-users] Cutter compensation with mill turning > > On Sunday 05 August 2018 09:07:29 Ken Strauss wrote: > > Looking at the drawings for position 9, page 78 of 738, I too am > confused. Can we be enlightened? IMO there are only 8 usable positions. > Which in the practical world, none are 100% accurate because no one sets > up a tool with the full side of its cutting edge inline with either > axis. Thats just asking for and usually getting a squeak/chatter and a > broken insert.
The I/J parameters on a G10 L1 allow the specification of the FRONTANGLE and BACKANGLE shown in the drawing. I'm guessing that 30-degrees is the default for these angles. ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
