On Saturday 23 February 2019 12:22:54 Jon Elson wrote: > On 02/23/2019 10:41 AM, Peter C. Wallace wrote: > > Umm just loaded a software stepgen (lastet master) and it > > has no such pins/parameters > > Right, MIN_LIMIT and MAX_LIMIT are not handled by stepgen or > any motion interface hardware, they are handled much higher > in LinuxCNC. To reach a smooth deceleration right at the > limit position requires it to be limited before the > trajectory planner. So, these parameters are picked up out > of the [JOINT_n] stanza by something in the motion section. > Even the G-code interpreter knows about them, as you will > get "program exceeds +X limit at line 1234" messages when > loading a program. > > Jon > I've seen that memo hundreds of times. Maddening when its only 1 thou outside of that limit. > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users
Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
