Hi guys I have a little problem... I have a mesa 5i25 7i76 combo which was working 4 months ago. I blew up a servo drive and only just got back to the project a couple of months ago. the original config stopped working when I started it up again and came up with a error message. "Pin 'hm2_5i25.0.7i76.0.0.input-00 does not exist" It is possible that I have damaged the mesa card when i blew up the servo drive.
My mesa card is not registering with the computer I think. when I use Pnconfig and try to connect a digital input up to the card it comes up with "Pin 'hm2_5i25.0.7i76.0.0.input-00 does not exist, but when I connect it up the with no inputs connected into the 7i76 it goes works fine. this leads me to believe that there may be some problems. The 7i76 leds both come on fine. I can't see any leds on the 5i25. also I have been trying for a couple of weeks to get the step and direction signals moving the servos and haven't had any luck which is why I eventually started wondering if the mesa card was working properly. Anyone have some ideas? regards Andrew _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
