On Monday 07 September 2020 16:01:05 Gene Heskett wrote: > On Monday 07 September 2020 14:57:13 Gene Heskett wrote: > > I just noted that when it starts building the splines on the > > flexgear, that the color is getting air and hair contaminated, > > turning frosty. So since I've got the extra snout installed, I'm > > wondering if its cooling too fast, so I did a tune->fan speed down > > to 52% to see if the slower cooling gives it time to flow smooth and > > restore the color. Report later after its done a few layers. > > > > Cheers, Gene Heskett > > It occured to me that less cooling aimed at the nozzle would also help > its ability to supply flow, so I am upping that about 1% a layer, up > to 104% so far, with no skip clicks from the extruder drive. Too bad I > can't control both at the layer count in cura, I think it might be > helpfull. > Another PS, I am up to 106% for flow, and the solid candy red color has returned to the splines, 23% for fan speed, I'd guess its turning 400 rpms, so no great cooling effect. This is a definite improvement in laying solid plastic.
So put this in your trivia basket. This piece is about done. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
