Gene, Is this printer controlled by LinuxCNC? I know you've been doing a lot of work making LCNC to work with the Pi but I don't remember if you were controlling your 3d printer or another machine with that.
El lun., 7 sept. 2020 a las 17:24, Gene Heskett (<ghesk...@shentel.net>) escribió: > On Monday 07 September 2020 16:01:05 Gene Heskett wrote: > > > On Monday 07 September 2020 14:57:13 Gene Heskett wrote: > > > I just noted that when it starts building the splines on the > > > flexgear, that the color is getting air and hair contaminated, > > > turning frosty. So since I've got the extra snout installed, I'm > > > wondering if its cooling too fast, so I did a tune->fan speed down > > > to 52% to see if the slower cooling gives it time to flow smooth and > > > restore the color. Report later after its done a few layers. > > > > > > Cheers, Gene Heskett > > > > It occured to me that less cooling aimed at the nozzle would also help > > its ability to supply flow, so I am upping that about 1% a layer, up > > to 104% so far, with no skip clicks from the extruder drive. Too bad I > > can't control both at the layer count in cura, I think it might be > > helpfull. > > > Another PS, I am up to 106% for flow, and the solid candy red color has > returned to the splines, 23% for fan speed, I'd guess its turning 400 > rpms, so no great cooling effect. This is a definite improvement in > laying solid plastic. > > So put this in your trivia basket. > > This piece is about done. > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > If we desire respect for the law, we must first make the law respectable. > - Louis D. Brandeis > Genes Web page <http://geneslinuxbox.net:6309/gene> > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
