Sheet metal bending. Made first prototype with bending radius same as sheet metal thickness but but as neutral line is in middle for bending radius more than twice the sheet thickness I suspect it is a good ideat to increase bending radius to twice the sheet metal thickness to reduce stress. Anyone here know anything about or have any experience?
Have at last had time to calibrate position gain with micro meter mesurement on machined metal part and also machine my first prototype part. Mikrokator is the most accurate measurement device I know about but although a machined part could be measured I am not immidiately sure if or how it could be done to measure machine accuracy. Anyone here have any idea how to measure it more accurately? Or where to find more information on how it shoulb be done? Decided it was time to get E-mail, payed for with a small fee instead of freely available. Anynone it it's possible to change address or I have to subscribe again? Regards Nicklas Karlsson _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
