> -----Original Message----- > From: Jon Elson [mailto:[email protected]] > Sent: November-27-20 11:41 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Installing LCNC on Raspberrypi 3B+ > > On 11/27/2020 12:53 PM, John Dammeyer wrote: > > I just put the brain dead LinuxCNC distribution onto an SD card. Then > > booted and pulled the ini and hal files from the PC into the > proper folder. > BDI (Brain Dead Install)? But, that's a 20 year old > system, X-86 only, and it would be hard to find hardware the > kernel would know how to install on. Or, am I hopelessly > out of date? > > Jon When it was announced that a Pi version of LinuxCNC 2.8 was available an image for the SD card was talked about. I went to the site and downloaded it. Don't remember exactly where.
https://forum.linuxcnc.org/18-computer/36879-raspberry-pi-4?start=440 John Dammeyer > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
