Well in that case it's cheaper than the Swiss one. What I have found so far is that the cheap metric tap+die+handle was fine for the occasional hole but really garbage for anything else. I'm definitely headed in the direction that the quality of the threaded hole is directly due to the quality of the tap (or die).
I've ordered one of each of 10-24, 1/4-20 and 3/8-16. Need to find some reasonable metric ones yet too. Give the last few days anguishing over HAL file parameters and Break Out Board issues the experiment this afternoon watching the tap thread was quite a treat. John > -----Original Message----- > From: Gerrit Visser [mailto:[email protected]] > Sent: July-07-21 5:21 PM > To: 'Enhanced Machine Controller (EMC)' > Subject: Re: [Emc-users] Power Tapping > > YG-1 is hardly no-name. > > https://www.yg1.kr/main.asp > > > > > Gerrit > > > -----Original Message----- > From: John Dammeyer <[email protected]> > Sent: July 7, 2021 7:37 PM > To: 'Enhanced Machine Controller (EMC)' <[email protected]> > Subject: Re: [Emc-users] Power Tapping > > It's an Amazon Prime product so shipping is free but yes, in Canadian $ half > the price of the Swiss one and probably should be 1/4 > the price since it's no name. > > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
