Where are you located? > -----Original Message----- > From: Gerrit Visser [mailto:[email protected]] > Sent: July-07-21 7:18 PM > To: 'Enhanced Machine Controller (EMC)' > Subject: Re: [Emc-users] Power Tapping > > I should have added YG-1's Canadian office info: http://yg1.ca/field.asp > > I'm back to practicing drilling and thread milling M6 in 1/2 aluminum plate > on Friday. My shop bult gantry mill/router has its swarf containment system > in place at last. > > Gerrit > > -----Original Message----- > From: John Dammeyer <[email protected]> > Sent: July 7, 2021 8:52 PM > To: 'Enhanced Machine Controller (EMC)' <[email protected]> > Subject: Re: [Emc-users] Power Tapping > > Well in that case it's cheaper than the Swiss one. What I have found so far > is that the cheap metric tap+die+handle was fine for the occasional hole > but really garbage for anything else. I'm definitely headed in the > direction that the quality of the threaded hole is directly due to the > quality of the tap (or die). > > I've ordered one of each of 10-24, 1/4-20 and 3/8-16. Need to find some > reasonable metric ones yet too. > > Give the last few days anguishing over HAL file parameters and Break Out > Board issues the experiment this afternoon watching the tap thread was quite > a treat. > > John > > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
