I commented out the two offending lines from the new configuration file. Now it doesn’t error out on the missing lines: #setp [HMOT](CARD0).dpll.01.timer-us -50 #setp [HMOT](CARD0).stepgen.timer-number 1 However, the very first error is the “Watchdog has bitten”.
It seems like an error in pncconf if it inserts dpll.01.timer-us where mesa software has no dpll pins or am I misunderstanding this? Alan > From: "Peter C. Wallace" <p...@mesanet.com> > Subject: Re: [Emc-users] Conversion from Linuxcnc 2.8.2 to master - now have > missing "dpll" pin > Date: October 24, 2022 at 10:01:26 PM CDT > To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> > > > On Mon, 24 Oct 2022, Alan Condit wrote: > >> Date: Mon, 24 Oct 2022 21:01:07 -0500 >> From: Alan Condit <condit.a...@gmail.com> >> Reply-To: "Enhanced Machine Controller (EMC)" >> <emc-users@lists.sourceforge.net> >> To: EMC-Users <Emc-users@lists.sourceforge.net> >> Subject: [Emc-users] Conversion from Linuxcnc 2.8.2 to master - now have >> missing "dpll" pin >> I am trying to get all of my machines running master on Debian Bullseye. >> This evening I got Linuxcnc compiled on my lathe. It errors out reporting a >> missing pin �.dpll", which has a set -50. I had no errors before I ran >> pncconf on my existing .conf file. The line that has the error did not exist >> in my .hal file prior to converting it. Is this related to the watchdog >> timer? >> >> Thanks, >> Alan > > There should not be any hal file changes needed between a 2.8 and 2.9 > so you should just use you original hal/ini files. > > The DPLL error is likely because pncconf inserted a DPLL related statement > but your firmware has no DPLL. If you want to use the pncconf created hal > file, just delete any line mentioning a DPLL. > > > > Peter Wallace _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
