Hello! I got stuck on yet another thing with laser build on the Biesse, this time it must be something more obvious and/or stupid than previous. This time it is 7i37com board. I had "normal" 7i37 there for switching some signals in control cabinet (servo enable relays, vfd run/stop etc) which was a mix of "active high" (for relays) and "active low" (for vfd) signals. Since this machine is getting rid of VFD and spindles and some other things that were using "active low" logic and I was short on 7i37 board for the other Biesse, I decided to get a 7i37com board from the magic box of leftovers from previous projects. It is just that I cannot get the outputs to work. I thought that wiring it would be easy task. Here is how it looks at the moment: https://photos.app.goo.gl/c6psF7ArigszcCTZA
Inputs are working. For the output power: P2 is 24VDC and 0VDC is on VC. The wires in output pins are those that were connected to "-" leg of output pin for "normal" 7i37 (and "+" leg had that P2 wire). 1251 is servo enable relay and that other wire is for machine power relay (other side of the relay coil is connected to 0VDC). Multimeter does not show any change of voltage on any of output pins if I try to change their state, it remains in 20-30 mV range above 0VDC (I am fiddling with gpio.nnn.is-output and optionally gpio.nnn.invert-output before dangling gpio.nnn.out). Should I see any voltage change there? I would expect it to be +24VDC (reach something around voltage on P2 wire) at some point but I do not get anything like that. Is that correct? I also thought about possibility of fiddling with wrong gpio pins. But since inputs are working and IN0 is gpio.024 on the 5i24 board (which is right as that board is connected to middle 50-pin socket) then 16 input pins later OUT0 should be gpio.040 and I am trying with any pins in range from 040 to 047. I would appreciate any tip on what am I missing or overlooking. Viesturs _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
