It is an ordinary very common encoder have with a zero output. It does not have any index-enable net just an output. All encoders I have seen with an index output have been like this so therefore assume it is a very common problem how to connect these and simple solution available.
I could of course create an index net or write a component with an IO output that write value only then edge is detected. Then it will be possible to connect this to joint index-enable as both are IO. Nicklas Karlsson sön 2025-05-04 klockan 10:26 +0100 skrev andy pugh: > On Sun, 4 May 2025 at 09:26, Nicklas SB Karlsson <n...@nksb.eu> wrote: > > > > Any simple solution to connect index pulse from encoder to joint > > index-enable? > > Are you sure you want to do that? Why? > > Typically the system sets the whole index-enable net, then when the > index pulse is seen it is taken low by the encoder counter, that > signals to the rest of the net that the index has been seen, > > Are you trying to home to index without an encoder counter? > _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
