On Mon, 9 Nov 2026 at 01:08, fxkl47BF--- via Emc-users
<[email protected]> wrote:
>
> i have a small cnc router that is driven by the parallel port of a pc
> i see at "https://www.linuxcnc.org/docs/html/drivers/hal_pi_gpio.html"; that i 
> can use the gpio pins of a raspberry pi for this
> is anyone doing this and can you share what you learned

There should be enough pins to replace a parallel port, however you
might have trouble with voltage levels.
Does your equipment work properly with 3.3V signals? And are any
inputs to the Pi at a safe voltage for the Pi? (switches and even
Proximity sensors can switch-to-gnd so are not a problem there)

I hesitate to recommend them, as PCW has a living to make, but there
are some cheap clones of the "7i92" board on AliExpress. None of them
bear any real similarity to a real 7i92, so I am unsure why they
picked that designation.
I recently bought one to see what they were like, and to be fair it's
quite nice, with a DIN-rail mounting case and two ethernet sockets for
smart-serial expansion boards.
The only real drawback over a real Mesa board is that the
documentation is terrible, support is likely to be nonexistent and for
some reason it insists on two separate 24V supplies, yet all GPIO is
5V.

The one that I got was this one:
https://www.aliexpress.com/item/1005010164851154.html
As is always the case with AliExpress, you have to look beyond the
headline price and factor in shipping. And bear in mind that as
someone else observed "it is like buying stuff from raccoons that have
no idea what anything is for or what it should cost"


--
atp
"A motorcycle is a bicycle with a pandemonium attachment and is
designed for the especial use of mechanical geniuses, daredevils and
lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1912


_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to