----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Better double check those specs. If I'm not mistaken the 'Slick' mags
put out higher voltage than
the original Eisemann's or the Bendix. Or so I've heard anyway.
Bob Saville
"William R. Bayne" wrote:
> ----[Please read http://ercoupers.com/disclaimer.htm before following
any advice in this forum.]----
>
> on 11/9/02 2:43 PM, Randy Helm at [EMAIL PROTECTED] wrote:
>
> > I have a 46 415C 85hp slick mags.
> > I need to know the gauge of wire for to replace the p lead (ignition
to
> > mag). The current one is getting frayed. What gauge, type etc.
> >
> > Thanks, Randy
> >
> Yo, Randy
>
> Forney Drawing F-54048 (& electrical diagram) shows part numbers
F-54048-25
> & 26 of 16 ga. shielded wire for the P-Leads.
>
> See also diagram of Ercoupe Service Memo 23 revised 6-10-46 shows these
as
> 415-54048-22 & 23. Both ends of shielding must be grounded.
>
> Hope this helps....sorry it took so long.
>
> Regards,
>
> William R. Bayne
> <____|(o)|____>
> (copyright 2002)
>
>
==========================================================================
====
> To leave this forum go to: http://ercoupers.com/lists.htm
==========================================================================
====
To leave this forum go to: http://ercoupers.com/lists.htm
<<attachment: winmail.dat>>
