----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
---------- From: "William R. Bayne" <[EMAIL PROTECTED]> Date: Wed, 04 Jun 2003 12:11:26 -0500 To: COUPERS - TECH <[email protected]> Subject: Re: [COUPERS-TECH] (Instrument) panel restoration > In the "but first" department, a non-professional should clean and use nail > polish, paint on a toothpick, or similar means to apply a single identifying > mark on the large end of the taper pin (which is obvious), and on the side > of the control next to the hole the large end of the taper pin exited (which > is not). Apply two daubs similarly on the other side before disassembly. Above should have read "control shaft" , or "shaft". Sorry. Regards. Willliam R. Bayne <_____|(o)|_____> Copyright 2002) ========================================================================== == == To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/ ========================================================================== ==== To leave this forum go to: http://ercoupers.com/lists.htm Search the archives on http://escribe.com/aviation/coupers-tech/
<<attachment: winmail.dat>>
