----[Please read http://ercoupers.com/disclaimer.htm before following any 
advice in this forum.]----


Eliacim.
I found strobes not very effective for collision prevention at daytime.
By watching the traffic on airports I found the beacons are better seen.
If you care about being seen I would leave the system as it is and turn it on when approaching an air field. This is the area where it is needed most.

If you insist on strobes for the homebuilt market, have your mechanic file a 337 and see if that goes trough. There are Faa-PMA strobes on the market too. I think there is a certain candle power required for a strobe on certified planes. I am not sure if your Mini-Strobe is designed to have that power output.

So instead of spending a hundred bucks for a strobe that might not fit and will cause certification trouble, why not spend 30 bucks more and buy a strobe that is designed to legally replace your rotating beacon?
Get one from Skyport:
FS4400-12V FLIGHT STROBE (intended for belly mount) 850 effective candle power - 12 volt-3 amp, with

CLEAR LENS. Available with RED LENS or combined RED-CLEAR LENS. (Add $10.00)

Directly replaces short life rotating beacons 3 ¾ in diameter................................................ $ 129.00

http://skyportservices.net/

Hartmut



----- Original Message ----- From: <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Thursday, February 09, 2006 12:22 AM
Subject: [COUPERS-TECH] Strobe question


----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----



Now... some welcome relief from SB32!!

My plane has some red Aeroflash beacons (top and bottom) which have two
problems:

1. They draw a whooping 10 amps, eating my generator's output (13 amps back on the good days, when it was young) so that if I run the beacon continuously per
regs, my battery is discharged by the time I land and I can't restart.

2. They are not as effective as strobes, for collision prevention.

I found some strobes (Kuntzleman SC103) which are lightweight and only draw 1/2 an ampere each. The problem is that they are meant for ultralights and are
not STC, PMA, FBI, CIA, FEMA, etc etc.

What would it require to install them legally in my plane?

Eliacim
N87071




==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm




==============================================================================
To leave this forum go to: http://ercoupers.com/lists.htm



Reply via email to