----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Good Morning, I just had a SB32 done on my Ercoupe this Sat. It came out great, no bad rivets were found. It took about 4 hours for the whole inspection. You must take off your wings to have this done and remove your side panels to reach inside. It was very hard to reach each rivet and is very important to make sure the probe touches it just right. I had my A&P and a Level III do the inspection. I do not have costs at this time. My A&P will put together a paper on what he found out about this process and I will share it with the group. Again, lets hope this does not become an AD. But, the Level III did put it into my log book just in case. Tony N94670 ============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
