----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Eliacim, If they replaced the cylinder to crankcase
o- ring they would have to pull the cylinder from the piston. I would first
check throttle linkage and carb heat control for full off position.
If they pulled the cylinder which they would have to to install the o-ring
it should have been honed and new rings installed. You mentioned new spark plugs
on top, how about the bottom? I'm not an expert in this field just some things I
would check. Dick L. 3041H
----- Original Message -----From: heavensoundsSent: Monday, June 19, 2006 9:50 PMSubject: [COUPERS-TECH] Short on power----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----After doing a lot of work on my plane during the last 2 weeks, we tested it today (hoping to be through) and it won't develop full power.The following work was done:1. Removed cylinder to fix helicoil and replaced it, (hopefully the repair shop did not to remove the piston from the cylinder...) . Used new intake and exhaust gaskets as well as new cylinder to crackcase O ring.2. New magneto harness3. New shielded spark plugs on top, elimminating the 90 degree cans.4. New impulse coupling and drive gear on right magneto5. Installed spark plug blisters.The engine starts quickly, runs smooth, and run up at 2,000 RPM (indicated) is perfect, showing slight magento drops and a larger drop with carb heat.However, the engine does not develop more than 2100 RPM indiated on the tach (1920 measured with an optical prop tach)After working for the last 3 days in 1 though 5 above, my AP and I did not have time to continue troubleshooting, and gave up for the day (and for the week, due to our schedules) (Yes, I am frustrated about driving , instead of flying to Terrell.)Next time we work on the plane (next week, after Terrell) we plan to do a compression check, since we suspect maybe the shop that fixed the helicoil may have pulled the piston out of the cylinder and disturbed the seals. Does that make any sense?Any other suggestions as to what to look for??Any and all advice will be appreciated.Eliacim============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
