----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
My exhausts have a hole drilled in them (mechanic did the drilling) and the probe gets put into the hole with a clamp. I believe they are all this way. - Jason -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Sent: Tuesday, June 27, 2006 5:24 PM To: [email protected] Subject: Re: [COUPERS-TECH] CHT or EGT ----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]---- EGT it is. Are the probes just clamped around the exhaust pipes or is it required to drill into the exhaust pipes? Eliacim Cortes N87071 Quoting Maynard Smith <[EMAIL PROTECTED]>: > E G T !! No question about it! And if you can swing it do all four > cylinders! > ============================================================= > > -------Original Message------- > > From: [EMAIL PROTECTED] > Date: 06/27/06 06:14:23 > To: [email protected] > Subject: [COUPERS-TECH] CHT or EGT > > ----[Please read http://ercoupers.com/disclaimer.htm before following any > advice in this forum.]---- > > > I know it is ideal to have both, but if installing only one first, which > one > gives the more valuable infromation to lean, EGT or CHT? > > Eliacim Cortes > > > > -- > This message has been scanned for viruses and > dangerous content by MailScanner, and is > believed to be clean. > > ============================================================================ = > > To leave this forum go to: http://ercoupers.com/lists.htm > > > > -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. ============================================================================ == To leave this forum go to: http://ercoupers.com/lists.htm ============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
