----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----Hi Al,
Been there, done that. It's just a flat piece of sheet metal, 0.025 thick. You can use the old one as a pattern and just match drill the rivet holes in the new one from the old one. Not a problem.
Syd
A DeMarzo wrote:
One question I'll ask from the experienced. The bottom piece of sheetmetal under the center section was removed. I have the old one and need to replace it. It appears that it can be replaced with sheet stock, but it also appears to have a slight bend in it. If it has a compound curve it may need to be ordered, but before I do that, I would like to try to make one myself. So to the guys who have done a center section, please advise.Al============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
