----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----
Ed; Are you working with a mechanic on this? Al DeMarzo Visit the Ercoupe Swap Page - Free and Easy http://www.ercoupeowners.com/swap/swapbook.htm ----- Original Message ----- From: Ed Olds To: Ercoupe Tech Group Sent: Monday, February 26, 2007 10:03 PM Subject: [COUPERS-TECH] Questions Folks, I am in the process of trying to get my 415-C in the air and am having a lot of problems. Without even going to the engine and gear issues, I have a have a lot of issues with missing nuts and bolts? I tried attaching several photos and asking for help in finding out what to do next, but got a message saying the messages were too large? Is there a limit on what can be sent in this group? Despite that, here are the questions, without pictures? Some of the missing screws/bolts are the ones that hold the footrest/brake housing. The system consists of a piece of plywood with two brackets to attach it to the floor and a metal plate that surrounds the yoke? The plate and brackets have no hardware? What type of fastener do I use for these holes? Next, it appears that the seat pan should be screwed to the spar and stiffeners? Is the pan screwed in? What size screw? I also have a fuel gauge located in the left wing, does that gauge show the level of fuel in all tanks? If it does, mine must be bad, because it shows "full" and my right tank is almost empty? And finally, the brake pedal was held on with what seemed to be non-standard hardware and we removed it to replace them? What size and type fasteners hold this on and which way does the pedal hang, with hole at top or bottom? Whooo! That's all for now, I hope? Ed Olds N3773H ============================================================================== To leave this forum go to: http://ercoupers.com/lists.htm
