Gwen:
The up stop is a shaft color behind the panel. There is probably another bolt hole 1" forward of the one in use. Just move the collar there. The down stop is a sleeve on the shaft behind the yoke. It will have to get 1" longer. New York is not New England? Thank goodness! I don't think I could take another New England Winter! John Cooper, A&P Skyport Services PO Box 249 4996 Delaware Tnpk Rensselaerville, New Amsterdam 12147 518 797-3064 Fax 518 797-3865 www.skyportservices.net _____ From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Glen Davis Sent: Wednesday, November 21, 2007 10:10 PM To: Ralph Haven; [email protected] Cc: Victor Rodriguez; geoff (N23GD) Subject: [ercoupe-tech] yoke travel Gang I have an Ercoupe whose panel was relocated about one inch aft by the former owner, John Rogers, now deceased. I am nearing the completion of a complete restoration and the mechanic doing the work, Victor, has repositioned the panel back to it's original location, like it was from the factory. When I mentioned to John that I was moving the panel back to the original position, he told me to make sure the "stops" on the yoke (control shaft) were placed back in the correct position of I would not get the correct elevator travel. I recently mentioned to Victor that the stops needed to be readjusted. He asked me to try to get more details on "the stops" and how to adjust them. Can anyone send me an email which I will forward to Victor so he understands what needs to be done and how? Thanks Glen Glen Davis 917 297 1111 www.ishootpictures.com www.ercoupepilot.com
