My gage has always run in the middle of the tube. That give it room to bobble around. When it starts to go up that means there is a problem with the return fuel. I would not want it running too high in the tube normally because then you have no warning before it overflows from a return flow problem.
Kevin --- In [email protected], Hartmut Beil <[EMAIL PROTECTED]> wrote: > > > Richard. > > I can understand your concern. > > Maybe it is good to know that I also have the bobber go only half way up the glass tube. It depends all on age and deterioration of the cork. > > To check how much fuel you really got when indicating "full" or half full in your eyes, just - on the ground- disconnect the hose to the gascolator and redirect into a 5 Gallon can. > Then open the header tank fuel valve. > You should at least be able to fill that canister. It is also a good way to measure and memorize the way the bobber looks when the gas tank is half full and empty. > > Hartmut > > > > > To: [EMAIL PROTECTED]; [EMAIL PROTECTED]: [EMAIL PROTECTED]: Mon, 6 Oct 2008 07:41:05 -0500Subject: RE: [ercoupe-tech] Electric Fuel Pump > > > > > Rich responded directly to me and added information about his problem: > My real concern is whether my center tank is actually getting > enough fuel. I wouldn't worry if I knew it was filling properly. > I bought a new glass sight gauge for the center tank from > Skyport and an only registers 1/2 way up the sight glass. > Saw a UTube video and that Coupe had the same gauge > and it was all the way to the top. I might be missing something > of course, but that's my little fuel problem or gauge problem > at the moment.Rich,That could be a variation of the gauge, fuel pump problems, fuel flowlimiter mis-sizing or a fault with the overflow return system. Let's check.It is important for the experts to know what is your plane's original modeland serial number. This tells a lot about the original fuel systemconfiguration to the experts. There have been some differences how the fuelreturn was configured. Please include that in your next post to the forum.Checking the overflow return system:Over-fill the nose tank up to the top then set the plane on level ground andwait five minutes for the extra to drain out. (You don't want the wingtanks to be too full when you do this.) Then, use a dip stick and measure the EXACT distance from the top of thefiller ring to the fuel and let us know. Also, measure how high the top ofthe sight gauge is from the bottom of its travel and report that to theforum as well. Mark that sight gauge spot for later comparison when you areup flying it often stays higher than that when you are flying.We've got a bunch of people who can tell if your fuel level is low.Fuel pump:It may be that your current engine-driven fuel pump is not pumping well andis about to fail. Was the disassembly and inspection really done at thelast annual inspection? If it wasn't done, maybe it should be done.Fuel flow restrictor:I can't, off the top of my head, remember the orifice size of the fuel flowrestrictor that should be in the output of the fuel pump. There's aspecific size that limits the fuel flow to what can be handled by theoverflow return system yet still deliver way more than the engine can use atfull power. Sometime today an expert will post a message with that orificesize.Main tank clogging:Have you checked inside the main fuel tanks for gunk around the outflowfittings? (This ought to also show when you drain fuel during preflight.)It's good to "vacuum" out the tanks with a pipe and hose - start a siphongoing and use the pipe/hose to vacuum up gunk from the bottom of the tanks.Fuel line clogged:I don't know how to best check this possibility. Watch for suggestions ifthe easier stuff above doesn't solve the problem.Ed > > > > > > _________________________________________________________________ > Get more out of the Web. Learn 10 hidden secrets of Windows Live. > http://windowslive.com/connect/post/jamiethomson.spaces.live.com- Blog-cns!550F681DAD532637!5295.entry?ocid=TXT_TAGLM_WL_domore_092008 >
