This is off the group:
.Don,
Ed here. There is no quote buss bar as one would think. On my 415c all there
was was a very long 10-32 screw where a whole gang of wires with terminals were
stacked on top of one another. So do what I did was to create a buss bar. Go
down to NAPA an purchase a terminal block and jump wire the gang of studs
together. Create two separate sets. One for the positive 12volts and one side
for the negative. Then you can bring all those wire that were on the 10-32
screws over to the 12volt side. Any ground wires can be place on the negative
side. Worked well for me. It makes things nice and neat. Good luck.
N3396H
Sent: Saturday, May 08, 2010 8:35 AM
Subject: [ercoupe-tech] Lost Buss Bar
There has to be one somewhere, but I cannot seem to locate it. Anybody have a
clue?
(No, not the kind that buses go to for a martini or a beer.)
