I would also like to know if there's been any progress on this. Especially from the command-line interface or another user-mode program when the master is in IDLE mode.
> -----Original Message----- > From: etherlab-users-bounces at etherlab.org [mailto:etherlab-users- > bounces at etherlab.org] On Behalf Of Kim H. Madsen > Sent: Thu Jan 27 12:05:42 CET 2011 > To: etherlab-users at etherlab.org > Subject: [etherlab-users] Beckhoff Slave Controllers and Device Reset > > > Any news on this issue? > > Best regards > Kim Hedegaard Madsen > > >> -----Original Message----- >> From: etherlab-users-bounces at etherlab.org [mailto:etherlab-users- >> bounces at etherlab.org] On Behalf Of Eugene Bordenkircher >> Sent: 13. oktober 2010 18:00 >> To: etherlab-users at etherlab.org >> Subject: [etherlab-users] Beckhoff Slave Controllers and Device Reset >> >> We are trying to perform a device reset of a Beckhoff Slave controller. The >> reset requires 3 consecutive writes to the appropriate register (0x40 or 0x41). >> >> As far as we can tell, there's no way for the EtherCAT master to send >> 3 consecutive register write frames. The master always seems to interject >> another frame in between. Is this a correct observation? >> If not, is there a way to perform these resets? If it is correct, is there a way to >> perform the reset with minor modifications to the master? >> >> Thank you for your help. >> >> Eugene T. Bordenkircher _______________________________________________ etherlab-users mailing list etherlab-users@etherlab.org http://lists.etherlab.org/mailman/listinfo/etherlab-users