A second ground circuit in a receptacle could be use for a isolated grounded. We use receptacles that are design for explosion proof areas. In some cases the isolated ground circuit may connected to a conductive chassis box or cabinet. In this case the chassis box and/or enclosure is isolated by standoff insulators from the building structure.
I made my PFC-50B charger isolated from the body of the EV by installing the charger in a non-conductive equipment box. Only the charger case is grounded. I also install my Li-Ion aluminum case cells in a non-conductive equipment box. When the batteries are charge, both the negative and positive circuit to the motor controller is also disconnected by the use of two contactors. When the charger is turn off, there are two contactors that disconnects the charger from the battery. If the charger has a bank of capacitors in it, and the charger is not disconnected from the battery pack, then the main battery keeps the capacitors charge up. Disconnecting or removable of a battery link could produce a spark, which has happen when I had flooded batteries. Roland ----- Original Message ----- From: Jay Summet<mailto:[email protected]> To: Roland<mailto:[email protected]> ; Electric Vehicle Discussion List<mailto:[email protected]> Sent: Sunday, November 15, 2015 10:37 AM Subject: Re: [EVDL] Extra ground wires on Nissan Leaf J1772 inlet & cable? All of the wiring diagrams I can find online only show five wires. Pilot/Proximity (I've identified those). Ground and the two hot (I've identified thoese). But they don't have two other wires connected to the ground wire anywhere. Are you saying that the two smaller green wires that are connected to the large green wire are part of a isolation ground circuit? Jay On 11/15/2015 10:12 AM, Roland wrote: > Just type in your search engine - J1772 wiring diagram and you will see > the light- > I am using a industrial 5 wire receptacle and plug in my EV that has a > extra isolation ground circuit. A isolation ground circuit is only > connected to the circuit and/or circuit board and nothing else. If the > isolation ground circuit shorts to a conductive housing, then there is a > ground detection circuit that opens up a contactor or a shunt type > commercial circuit breaker. > Roland > > ----- Original Message ----- > *From:* Jay Summet via EV > <mailto:[email protected]<mailto:[email protected]>> > *To:* Electric Vehicle Discussion List > <mailto:[email protected]<mailto:[email protected]>> > *Sent:* Sunday, November 15, 2015 6:08 AM > *Subject:* Re: [EVDL] Extra ground wires on Nissan Leaf J1772 inlet > & cable? > > Yes, I've taken out that LED light already, and it has a separate > set of > wires. > > Jay > > On 11/14/2015 11:17 PM, Tom Keenan wrote: > > If I remember correctly, the charging area was unlighted until > the 2013 model year. There is a LED light between the CHaDeMo port > and the J1772 inlet on 2013 and newer model years. Not sure if the > J1772 wiring involved anything with the lighting setup. > > > > Tom Keenan > > > >> On Nov 14, 2015, at 7:54 PM, Jay Summet via EV > <[email protected]<mailto:[email protected]> > <mailto:[email protected]<mailto:[email protected]>>> wrote: > >> > >> The charging "bay/door area" on the Leaf is lighted, but that > light is in a different location and separate from the actual inlet. > >> > >> I don't see any LED's/lights inside the inlet itself (and I > can't find any other wires for LED's (unless they are powered by the > pilot/proximity lines themselves...) > >> > >> Jay > >> > >>> On 11/14/2015 10:02 PM, Alan Arrison via EV wrote: > >>> Jay, is the inlet lighted? > >>> Could it be ground returns for LED's? > >>> > >>> Al > >>> > >>>> On 11/12/2015 9:34 PM, Jay Summet via EV wrote: > >>>> I've taken the J1772 inlet & cable from my salvaged (2013) > Nissan Leaf > >>>> and am planning on connecting it up to the new charger for my S-10 > >>>> pickup truck conversion. > >>>> > >>>> It has the standard 5 pins (Hot/Hot/Ground/Proximity/Pilot). > The two > >>>> hots connect to two large orange wires. The Proximity/Pilot > connect > >>>> to two small wires that come out of the harness close to the > inlet. > >>>> > >>>> However, there are THREE green wires that emerge from the back > end of > >>>> the harness. One large, which is connected to the ground pin > on the > >>>> J1772 inlet, and two other smaller green wires that are > connected to > >>>> the large green wire via a shared ring terminal. I don't know what > >>>> these two small green wires go to, but it's not any of the > pins on the > >>>> J1772 inlet! > >>>> > >>>> When I disconnected them from the ring terminal, they do not have > >>>> connectivity to any of the other wires, or to any of the pins > on the > >>>> inlet. As far as I can tell, they just go into the harness heading > >>>> towards the inlet and disappear! > >>>> > >>>> The only thing I can think of is that they are routed near to > the HOT > >>>> wires in such a way that if the hot wires are compromised they may > >>>> short out to ground? > >>>> > >>>> Has anybody got a definitive answer to what these two guys are > for? > >>>> I can post photos of them if you want to see, but I figure that > >>>> anybody who already knows the answer won't need the photos.... > >>>> > >>>> Thanks, > >>>> Jay > >>>> _______________________________________________ > >>>> UNSUBSCRIBE: > http://www.evdl.org/help/index.html#usub<http://www.evdl.org/help/index.html#usub> > >>>> > http://lists.evdl.org/listinfo.cgi/ev-evdl.org<http://lists.evdl.org/listinfo.cgi/ev-evdl.org> > >>>> Read EVAngel's EV News at > http://evdl.org/evln/<http://evdl.org/evln/> > >>>> Please discuss EV drag racing at NEDRA > >>>> > (http://groups.yahoo.com/group/NEDRA<http://groups.yahoo.com/group/NEDRA>) > >>> > >>> _______________________________________________ > >>> UNSUBSCRIBE: > http://www.evdl.org/help/index.html#usub<http://www.evdl.org/help/index.html#usub> > >>> > http://lists.evdl.org/listinfo.cgi/ev-evdl.org<http://lists.evdl.org/listinfo.cgi/ev-evdl.org> > >>> Read EVAngel's EV News at > http://evdl.org/evln/<http://evdl.org/evln/> > >>> Please discuss EV drag racing at NEDRA > >>> > (http://groups.yahoo.com/group/NEDRA<http://groups.yahoo.com/group/NEDRA>) > >> _______________________________________________ > >> UNSUBSCRIBE: > http://www.evdl.org/help/index.html#usub<http://www.evdl.org/help/index.html#usub> > >> > http://lists.evdl.org/listinfo.cgi/ev-evdl.org<http://lists.evdl.org/listinfo.cgi/ev-evdl.org> > >> Read EVAngel's EV News at http://evdl.org/evln/<http://evdl.org/evln/> > >> Please discuss EV drag racing at NEDRA > (http://groups.yahoo.com/group/NEDRA<http://groups.yahoo.com/group/NEDRA>) > >> > _______________________________________________ > UNSUBSCRIBE: > http://www.evdl.org/help/index.html#usub<http://www.evdl.org/help/index.html#usub> > > http://lists.evdl.org/listinfo.cgi/ev-evdl.org<http://lists.evdl.org/listinfo.cgi/ev-evdl.org> > Read EVAngel's EV News at http://evdl.org/evln/<http://evdl.org/evln/> > Please discuss EV drag racing at NEDRA > (http://groups.yahoo.com/group/NEDRA<http://groups.yahoo.com/group/NEDRA>) > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.evdl.org/private.cgi/ev-evdl.org/attachments/20151115/6d45808c/attachment.htm> _______________________________________________ UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub http://lists.evdl.org/listinfo.cgi/ev-evdl.org Read EVAngel's EV News at http://evdl.org/evln/ Please discuss EV drag racing at NEDRA (http://groups.yahoo.com/group/NEDRA)
