On 27 Feb 2017 at 20:16, Jay Summet via EV wrote: > My plan was to hit it with a bit of sand paper just before connecting.
Again, I'm not an expert, but I think I remember reading that sandpaper isn't so good for this. It roughens the surfaces, and that actually reduces the heat transfer. Someone correct me if this is wrong, but I think a very fine abrasive compound on the mating surfaces might improve their flatness and fit, and thus the heat transfer. Maybe something like jeweler's rouge? And I think you'd probably still need heatsink compound. David Roden - Akron, Ohio, USA EVDL Administrator = = = = = = = = = = = = = = = = = = = = = = = = = = = = = EVDL Information: http://www.evdl.org/help/ = = = = = = = = = = = = = = = = = = = = = = = = = = = = = Note: mail sent to "evpost" and "etpost" addresses will not reach me. To send a private message, please obtain my email address from the webpage http://www.evdl.org/help/ . = = = = = = = = = = = = = = = = = = = = = = = = = = = = = _______________________________________________ UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub http://lists.evdl.org/listinfo.cgi/ev-evdl.org Read EVAngel's EV News at http://evdl.org/evln/ Please discuss EV drag racing at NEDRA (http://groups.yahoo.com/group/NEDRA)