Since the service pack is a full install, you can put the rollup 3 MSP in the Updates folder of the SP3 installer and do it all in one pass.
DAMIEN SOLODOW Systems Engineer 317.447.6033 (office) 317.447.6014 (fax) HARRISON COLLEGE From: [email protected] [mailto:[email protected]] On Behalf Of Leedy, Andy Sent: Wednesday, December 11, 2013 12:32 PM To: [email protected] Subject: [Exchange] Applying Service Pack 3 to Exchange 2010 I just want to check to see if I'm correct before applying the latest Service pack and rollups to our Exchange environment. We have 2 CAS/HUBs and 2 DAGS in an active passive failover setup. All the servers are currently running Exchange 2010 Service Pack 2 rollup 2. I want to bring everything up to the latest. So, I assume I start with the CAS/HUB and apply SP3 and then rollup 3 one server at a time. Then do the update the passive dag server, failover and update the other DAG. Mainly what I'm looking to find out is if I can go directly from "Service Pack 2 Rollup 2" to "Service pack 3" and then just apply "SP3 Rollup 3". Any known issues with SP3 Rollup 3 or gotchas you can think of would greatly appreciated as well. Thanks so much, Andy Leedy ********************************************************************** CONFIDENTIALITY NOTICE - The information transmitted in this message is intended only for the person or entity to which it is addressed and may contain confidential and/or privileged material. Any review, retransmission, dissemination or other use of this information by persons or entities other than the intended recipient is prohibited. If you received this in error, please contact the sender and destroy all copies of this document. Thank you. Henry Schein Animal Health **********************************************************************
