Jean-Michel Dault wrote:
>
> Do you have an internal or external modem?
>
> Can you post the output of your "setserial" command? It seems like a bad
> configuration...
>
> Jean-Michel Dault
> [EMAIL PROTECTED]
> [EMAIL PROTECTED]
>
> On Tue, 15 Jun 1999, Andrew MItchell wrote:
>
> > Date: Tue, 15 Jun 1999 19:06:54 +1200
> > From: Andrew MItchell <[EMAIL PROTECTED]>
> > Reply-To: [EMAIL PROTECTED]
> > To: [EMAIL PROTECTED]
> > Subject: [expert] Modem bandwidth problems after upgrade to Mandrake 6.0
> >
> > After upgrading to mandrake 6.0, incoming modem bandwidth has been
> > limited to 1k/sec, which is very annoying, as it is almost impossible to
> > do anything. I've run shapecfg, and nothing is enabled there, and I
> > don't know where else to look. Hopefully this can be resolved soon, as
> > it has been about the only problem i've have with 6.0 so far.
> >
> > PS: I sent this to the newbie list a week or so ago but got no reply, so
> > hopefully someone here can help
It's an internal 33.6k modem, and here's the output of setserial:
/dev/cua1, Line 1, UART: 16550A, Port: 0x02f8, IRQ: 3
Baud_base: 115200, close_delay: 50, divisor: 0
closing_wait: 3000, closing_wait2: infinte
Flags: spd_normal skip_test
--
/===================================================\
{ Andrew Mitchell }
{ Email [EMAIL PROTECTED] }
{ Home Page http://members.tripod.com/Ajmitchell/ }
{ ICQ 11392490 (ajmitch) }
\===================================================/
