On Tue, 24 Aug 1999, you wrote:
> John,
>
> Is the 850MB (boot) a SCSI drive? If so, you may want to check
> that lilo is configured properly. I had a similar problem when
> I put together a SCSI system. Here is my /etc/lilo.conf file
> if it is at all helpful (of course **change it to suit your system
> configuration** and run /sbin/lilo to activate changes):
>
Nope. 850 MB Boot disk is IDE. The 10.5 GB (which is only
seen as 8.5 GB) is SCSI.
I appreciate the help. Further investigation (with the boot
floppy) seems to indicate that it's trying to boot off
/dev/sda1, despite the fact that when it asked where to put
LILO, I told it /dev/hda Master Boot Record.
When booting with the boot floppy(created at install,) it
comes up with LILO and then a message saying hit "enter" to
boot normally from /dev/sda1 or type "rescue" to use a
rescue disk.
