I recently installed a linksys fast ehternet 10/100 card on my system. I had
to use compile the driver(tulip.c) from the diskette to make my card work. I
configured as a module.
Sridhar
----- Original Message -----
From: "Jayson S Baird" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, April 07, 2000 12:33 PM
Subject: [expert] Tulip NIC problem
> When using Mandrake 7.0 after install, it fails to access the
> network. ifconfig reads that my mask, IP and broadcast addresses are
> correct and my default route is set correctly through route. The light on
> my hub fails to light up though. My card works in RedHat 6-6.2 and just
> for some reason doesn't want to work in Mandrake. DrakX successfully found
> my card and in bootup it says it is starting up eth0. Any ideas on how to
> remedy this problem?
>
> Jay
>
> Jayson Baird - Kansas State University ==== CNS UNIX Administrator
> "My only skill as a programmer is twisted cleverness..'Click mouse to
> continue *click* release to detonate.'"
>
>
