Interesting. Their PCMCIA card doesn't require any special drivers . .
..
On Fri, 07 Apr 2000, you wrote:
| I recently installed a linksys fast ehternet 10/100 card on my system. I had
| to use compile the driver(tulip.c) from the diskette to make my card work. I
| configured as a module.
|
| Sridhar
|
| ----- Original Message -----
| From: "Jayson S Baird" <[EMAIL PROTECTED]>
| To: <[EMAIL PROTECTED]>
| Sent: Friday, April 07, 2000 12:33 PM
| Subject: [expert] Tulip NIC problem
|
|
| > When using Mandrake 7.0 after install, it fails to access the
| > network. ifconfig reads that my mask, IP and broadcast addresses are
| > correct and my default route is set correctly through route. The light on
| > my hub fails to light up though. My card works in RedHat 6-6.2 and just
| > for some reason doesn't want to work in Mandrake. DrakX successfully found
| > my card and in bootup it says it is starting up eth0. Any ideas on how to
| > remedy this problem?
| >
| > Jay
| >
| > Jayson Baird - Kansas State University ==== CNS UNIX Administrator
| > "My only skill as a programmer is twisted cleverness..'Click mouse to
| > continue *click* release to detonate.'"
| >
| >
--
"Brian, the man from babbleon-on" [EMAIL PROTECTED]
Brian T. Schellenberger http://www.babbleon.org
Support http://www.eff.org. Support decss defendents.
Support http://www.programming-freedom.org. Boycott amazon.com.
