here are the outputs you requested...and I also discovered my floppy
drive doesn't work either...and it is just a plain old 1.44 3 1/2
drive...nothing elaborate about it...the only drives I can access are
the 2 windoze drives...no cdrw or floppy output at all.....hope this
will finally get this going....I like the distro...hate the problems
Jim
Here is the dmesg output:
Linux version 2.2.16-9mdk ([EMAIL PROTECTED]) (gcc
version 2.95.3 19991030 (prerelease)) #1 Thu Jun 22 17:04:01 PDT 2000
Detected 451020 kHz processor.
ide_setup: hdc=ide-scsi
Console: colour VGA+ 80x25
Calibrating delay loop... 897.84 BogoMIPS
Memory: 127608k/131008k available (1228k kernel code, 412k reserved,
1688k data, 72k init, 0k bigmem)
Dentry hash table entries: 262144 (order 9, 2048k)
Buffer cache hash table entries: 131072 (order 7, 512k)
Page cache hash table entries: 32768 (order 5, 128k)
VFS: Diskquotas version dquot_6.4.0 initialized
CPU: L1 I Cache: 32K L1 D Cache: 32K
CPU: L2 Cache: 256K
CPU: AMD AMD-K6(tm) 3D+ Processor stepping 01
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.35a (19990819) Richard Gooch ([EMAIL PROTECTED])
PCI: PCI BIOS revision 2.10 entry at 0xfb4f0
PCI: Using configuration type 1
PCI: Probing PCI hardware
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
TCP: Hash tables configured (ehash 131072 bhash 65536)
Initializing RT netlink socket
Starting kswapd v 1.5
Detected PS/2 Mouse Port.
Serial driver version 4.27 with MANY_PORTS MULTIPORT SHARE_IRQ enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
pty: 256 Unix98 ptys configured
apm: BIOS version 1.2 Flags 0x07 (Driver version 1.13)
Real Time Clock Driver v1.09
RAM disk driver initialized: 16 RAM disks of 4096K size
Uniform Multi-Platform E-IDE driver Revision: 6.30
ide: Assuming 33MHz system bus speed for PIO modes; override with
idebus=xx
ALI15X3: IDE controller on PCI bus 00 dev 78
ALI15X3: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:pio
hda: WDC AC310200R, ATA DISK drive
hdb: Maxtor 84320D4, ATA DISK drive
hdc: CREATIVE CD-RW RW4224E, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: WDC AC310200R, 9787MB w/512kB Cache, CHS=1247/255/63, UDMA(66)
hdb: Maxtor 84320D4, 4120MB w/256kB Cache, CHS=525/255/63, UDMA(33)
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md driver 0.90.0 MAX_MD_DEVS=256, MAX_REAL=12
raid5: measuring checksumming speed
raid5: MMX detected, trying high-speed MMX checksum routines
pII_mmx : 953.643 MB/sec
p5_mmx : 921.639 MB/sec
8regs : 619.506 MB/sec
32regs : 441.579 MB/sec
using fastest function: pII_mmx (953.643 MB/sec)
scsi : 0 hosts.
scsi : detected total.
md.c: sizeof(mdp_super_t) = 4096
Partition check:
hda: hda1 hda2 < hda5 hda6 hda7 >
hdb: hdb1
autodetecting RAID arrays
autorun ...
... autorun DONE.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 72k freed
Adding Swap: 248968k swap-space (priority -1)
[root@localhost /root]# cat /proc/pci
PCI devices found:
Bus 0, device 0, function 0:
Host bridge: Acer Labs M1541 Aladdin V (rev 4).
Slow devsel. Master Capable. Latency=32.
Non-prefetchable 32 bit memory at 0xe0000000 [0xe0000000].
Bus 0, device 1, function 0:
PCI bridge: Acer Labs M5243 AGP (rev 4).
Slow devsel. Master Capable. Latency=32. Min Gnt=12.
Bus 0, device 2, function 0:
USB Controller: Acer Labs M5237 USB (rev 3).
Medium devsel. Fast back-to-back capable. IRQ 11. Master
Capable. Late
ncy=32. Max Lat=80.
Non-prefetchable 32 bit memory at 0xe9001000 [0xe9001000].
Bus 0, device 7, function 0:
ISA bridge: Acer Labs M1533 Aladdin IV (rev 195).
Medium devsel. Master Capable. No bursts.
Bus 0, device 9, function 0:
Ethernet controller: Realtek 8139 (rev 16).
Medium devsel. Fast back-to-back capable. IRQ 5. Master
Capable. Laten
cy=32. Min Gnt=32.Max Lat=64.
I/O at 0xe000 [0xe001].
Non-prefetchable 32 bit memory at 0xe9000000 [0xe9000000].
Bus 0, device 10, function 0:
Multimedia audio controller: Unknown vendor Unknown device (rev 5).
Vendor id=1102. Device id=2.
Medium devsel. Fast back-to-back capable. IRQ 9. Master
Capable. Laten
cy=32. Min Gnt=2.Max Lat=20.
I/O at 0xe400 [0xe401].
Bus 0, device 10, function 1:
Input device controller: Unknown vendor Unknown device (rev 5).
Vendor id=1102. Device id=7002.
Medium devsel. Fast back-to-back capable. Master Capable.
Latency=32.
I/O at 0xe800 [0xe801].
Bus 0, device 15, function 0:
IDE interface: Acer Labs M5229 TXpro (rev 194).
Medium devsel. Fast back-to-back capable. Master Capable.
Latency=32.
Min Gnt=2.Max Lat=4.
I/O at 0xf000 [0xf001].
Bus 1, device 0, function 0:
VGA compatible controller: NVidia Unknown device (rev 17).
Vendor id=10de. Device id=28.
Medium devsel. Fast back-to-back capable. IRQ 10. Master
Capable. Late
ncy=32. Min Gnt=5.Max Lat=1.
Non-prefetchable 32 bit memory at 0xe4000000 [0xe4000000].
Prefetchable 32 bit memory at 0xe6000000 [0xe6000008].
[root@localhost bin]# cat /usr/bin/lspcidrake
#!/usr/bin/perl
use lib qw(/usr/lib/libDrakX);
use commands;
commands::lspci;
[root@localhost bin]# cat /etc/fstab
/dev/hda5 / ext2 defaults 1 1
none /dev/pts devpts mode=0620 0 0
/dev/hda7 /home ext2 defaults 1 2
/dev/cdrom /mnt/cdrom iso9660 ro,nosuid,noauto,exec,user,nodev
0 0
/dev/fd0 /mnt/floppy vfat
sync,nosuid,noauto,user,nodev,unhide 0 0
/dev/hda1 /mnt/win_c vfat user,exec,umask=0 0 0
/dev/hdb1 /mnt/win_c2 vfat user,exec,umask=0 0 0
none /proc proc defaults 0 0
/dev/hda6 swap swap defaults 0 0
