Klar Brian D Contr MSG SICN wrote:
>
> Ok. Here is lilo.conf. As you can see I boot from floppy.
>
> [root /mnt/floppy] cat etc/lilo.conf
>
> boot=/dev/fd0
> timeout=100
> message=/boot/message
> prompt
> image=/vmlinuz-2.2.18-11mdk
> label=linux
> root=/dev/sdb2
> append=" hdd=ide-scsi"
> initrd=/initrd.img
>
> Here is /etc/modules as setup by mandrake setup (install)
>
> [root /etc] cat modules
> # /etc/modules: kernel modules to load at boot time.
> #
> # This file should contain the names of kernel modules that are
> # to be loaded at boot time, one per line. Comments begin with
> # a `#', and everything on the line after them are ignored.
>
> scsi_hostadapter
> scsi_hostadapter1
> ide-scsi
> ide-floppy
> bttv
>
> Here is Dmesg. This is a fresh install, nothing updated. I dont
> even think I added any software to it yet. I am not worried about
> the isa cards, one is modem (I now have dsl) and my sound card isa
> now works after I copied my isapnp.conf from my 7.2 partition.
>
> Thanks for the help in this.
We still have the strange access to hdb as if it were ide-scsi:
hdb:<3>ide-scsi: hdb: unsupported command in request queue (0)
end_request: I/O error, dev 03:40 (hdb), sector 0
unable to read partition table
If it is posible to physically remove the SCSI adaptor, try that.
Your SCSI emulation certainly is working and recognises 2 devices,
but only tells us about one of them. Try physically removing the
zip drive?
--
Regards,
Ron. [au]
