I will try this however when I did the install, all drives were attached to system. /dev/sdb4 exists as does hdb4.
[root@mrroboto dev]# ls -al sda4 brw-rw---- 1 root disk 8, 4 Sep 28 14:08 sda4 [root@mrroboto dev]# ls -al sdb4 brw-rw---- 1 root disk 8, 20 Sep 28 14:08 sdb4 [root@mrroboto dev]# ls -al hdb4 brw------- 1 root disk 3, 68 Sep 28 14:08 hdb4 mcc/mount points ?? Brian D. Klar - CVE OTS WPAFB -----Original Message----- From: Charles A Edwards [mailto:[EMAIL PROTECTED]] Sent: Friday, October 11, 2002 2:40 PM To: [EMAIL PROTECTED] Subject: Re: [expert] Iomega Zip not detected under v9.0 On Fri, 11 Oct 2002 14:14:43 -0400 Klar Brian D Contr MSG/SICN <[EMAIL PROTECTED]> wrote: > Here is the output of your request... > > [root@mrroboto root]# mount -a > mount: /dev/sda4 is not a valid block device Go into mcc/mount points and create the device there. If there is no sda4 entry there for your drive the easiest solution is for you to do an Expert/Upgrade install with the drive connected so that the installer can create the device. You will not need to select any pkgs for installation and you can skip the network and printer config. The whole process takes between 10-15 min. Charles --------------------------- The power to destroy a planet is insignificant when compared to the power of the Force. - Darth Vader ---------------------- Charles A Edwards [EMAIL PROTECTED] ----------------------
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
